characteristic typical min/max ta= 25 oc ta = -40 oc to +85 oc frequency 10 - 640 mhz 10 - 640 mhz typical intermodulation performance at 25 o c second order harmonic intercept point ................ +54 dbm second order two tone intercept point ................. +49 dbm third order two tone intercept point ..................... +42 dbm legend +25 oc +85 oc - - - - - - -40 oc power vdc +15 +15 ma 180 195 max. rf amplifier model QBH-5695PM features superior phase noise performance operating temp. -40 oc to +85 oc environmental screening available notes: care should always be taken to effectively ground the case of each unit. vswr in 1.3:1 2.0:1 max. out 1.6:1 2.0:1 max. reverse isolation (db) 17 15 min. gain (db) 13.0 12.0 min./14.0 max. specifications typical performance data absolute maximum ratings operating temperature .............................. -55oc to +125 oc storage temperature ................................. -62oc to +125 oc dc voltage @ +25 oc .... ...................................... +17 volts continuous rf input power .................................. +16 dbm junction temperature of rf xsistor ......................... +200 oc junction to case temperature rise (tjc) ................... +45 oc frequency typical 100 hz 1 khz 10 khz 100 khz 1 mhz guarantee -155 -170 -175 -175 -165 -175 -180 -182 -182 -175 guaranteed phase noise performance (dbc/hz) rev. 6/25/07 10 hz -145 -160 available as: QBH-5695PM, 4 pin .450? sq. surface mount (sm3) noise figure (db) 6.0 8.0 max. parameters are measured in a 50 ohm system @ the nominal dc supply voltage. *25.0 dbm min. @ 640 mhz. power @ 1 db comp. (dbm) 27.0 26.0 min. * 2.0 1.5 1.0 2.0 1.5 1.0 4 11 + 29 + 28 + 27 + 26 + 25 0 -10 -20 -30 -40 14 15 13 12 start 10 mhz stop 640 mhz start 10 mhz stop 640 mhz start 10 mhz stop 640 mhz start 10 mhz stop 640 mhz start 10 mhz stop 640 mhz start 10 mhz stop 640 mhz 8 7 6 5 gain (db) reverse isolation (db) noise figure (db) input vswr output vswr 1 db comp. (dbm) * 100 10k 1k 100k -140 -160 -170 -180 -190 -130 _______guarantee __ __ __ typical -150 residual phase noise test conditions: carrier frequency: 600 mhz power output: +27.0 dbm temperature: 25 oc agilent es5500 system 1 m 10 phase noise (dbc/hz) spectrum microwave 2144 franklin drive n.e. palm bay, florida 32905 ph (888) 553-7531 fax (888) 553-7532 spectrum microwave (europe) 2707 black lake place philadelphia, pa. 19154 ph (215) 464-4000 fax (215) 464-4001 www.spectrummicrowave.com
|
